Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
; Ueno, Fumiyoshi
JNC TN9400 2000-017, 10 Pages, 2000/03
lt is difficult to get hold the behave of growth of cavity which nucleates in grain boudaly in experimental observation. lt is considerd that numerical simulation is effective for the grasp of behave of cavity growth, because it is able to grasp the microscopic behavior of internal material whici is hardly observation. We examine the factor that the diffusive ratio and the stress etc., affected growth of cavity on grain boundary with numerical simulation using diffusive equation. As the result, a following knowledge was obtained. (1)With dominant of grain boundary diffusion, the shape of cavity transitions from quasi-equilibrium to crac-like. ln other hand, with dominant of surface diffusion, cavity grows up with initial shape. (2)With dominate of grain boundary diffusion, it accelerates the growth rate of the cavity near the tip by grain boundaly diffusion induced stressing perpendicular to gain boundary (3)With dominant of surface diffusion, the distribution of chemical potential is uniformity on cavity surface. ln other hand, with dominant of grain boundary diffusion compare to that of surface diffusion, the gradient of chemical potential is increased at the tip of cavity.
; Yamagata, Ichiro; Donomae, Takako; Akasaka, Naoaki
JNC TN9400 2000-046, 24 Pages, 2000/02
lt is well known that solute atoms are segregated on surface, grain boundary, etc. and composition changed partially in irradiated austenitic stainless steel. For understanding radiation induced segregation (RIS), we adopt a Fe-15Cr-20Ni-x (x: Si, Mo) which is basically alloy system in PNC1520, and size of Si, Mo are different from matrix atoms to investigate RIS behaviors. The specimens were irradiated by "Joyo" fast reactor that irradiation condition is 3.5 10 n/m (E>0.1Mev) at 476C. After irradiation, the specimen were observed and analyzed with EDS (Energy Dispersive X-ray Spectroscope) of 400kV TEM (Transmission Electron Microscope). The behavior of RIS depends on size of solute atoms of alloy. For example, oversized atoms are decreased and undersized atoms are increased in sink. RIS of voids are as same as or more than grain boundaries and smaller than precipitates. The void denuded zone was existed nearby G.B. in case of combinations between the grains from G.B.0ne of the reasons in this, the voids swepted by moving G.B. in radiation induced G.B. migration.
Ishitsuka, Etsuo; Kawamura, Hiroshi; Terai, Takayuki*; Tanaka, Satoru*; Uda, Minoru*
Fusion Technology 1998, 2, p.1281 - 1284, 1998/00
no abstracts in English
Ono, K.*; Furuno, Shigemi; Hojo, Kiichi; *
Microstructures and Functions of Materials (ICMFM 96), 0, p.273 - 276, 1996/00
no abstracts in English
Shiraishi, Kensuke; *; *; *
Japanese Journal of Applied Physics, 31(12A), p.L1675 - L1678, 1992/12
Times Cited Count:0 Percentile:0(Physics, Applied)no abstracts in English
*; *; *; *
Japanese Journal of Applied Physics, 31(8A), p.L1037 - L1040, 1992/08
Times Cited Count:5 Percentile:32.8(Physics, Applied)no abstracts in English
; Akabori, Mitsuo; Shiba, Koreyuki
Funtai Oyobi Fummatsu Yakin, 30(5), p.178 - 183, 1983/00
no abstracts in English